Using Artificial Neural Network for Estimation of Density and Viscosities of Biodiesel–Diesel Blends

Document Type : Research Paper

Authors

1 Catalyst Research Center, Chemical Engineering Department, Faculty of Engineering, Razi University, Kermanshah, I. R. Iran

2 Chemical Engineering Department, Faculty of Energy, Kermanshah University of Technology, Kermanshah, I. R. Iran

3 Faculty of Mechanical Engineering, Sharif University of Technology, Tehran, I. R. Iran

Abstract

In recent years, biodiesel has been considered as a good alternative of diesel fuels. Density and viscosity are two important properties of these fuels. In this study, density and kinematic viscosity of biodiesel-diesel blends were estimated by using artificial neural network (ANN). A three-layer feed forward neural network with Levenberg-Marquard (LM) algorithm was used for learning empirical data (previous studies data and this study empirical data). Input data for estimating density and kinematic viscosity includes components volume fraction, temperature and pure component properties (pure density at 293.15 K and pure kinematic viscosity at 313.15 K). Results of neural network simulation for density and kinematic viscosity showed a high accuracy (mean relative error for density and kinematic viscosity are 0.021% and 0.73%, respectively).
 

Keywords


[1] Geacai, S., Iulian, O. and Nita, I. (2015) “Measurement, correlation and prediction of biodiesel blendsviscosity.” Fuel, Vol. 143, pp.268–274.
[2] Gülüm, M. and Bilgin, A. (2015). “Density, flash point and heating value variations of corn oil biodiesel–diesel fuel blends.” Fuel Processing Technology, Vol.134, pp.456–464.
[3] Knothe, G., Gerpen, J.V. and Krahl, J. (2005). The biodiesel handbook. IL: AOCS Press.  
[4] Ma, F.R. and Hanna, M.A. (1999). “Biodiesel production: a review.” Bioresour. Technol., Vol. 70, pp. 1–15.
[5] Benjumea, P., Agudelo, J. and Agudelo, A. (2008). “Basic properties of palm oil biodiesel–diesel blends.” Fuel, Vol. 87, pp. 2069–2075.
[6] Yoon, S.H., Park, S.H. and Lee, C.S. (2008). “Experimental investigation on the fuel properties of biodiesel and its blends at various temperatures.” Energy Fuels, Vol. 22, pp. 652–656.
[7] Alptekin, E. and Canakci, M. (2008). “Determination of the density and the viscosities of biodiesel–diesel fuel blends.” Renewable Energy, Vol. 33, pp. 2623–2630.
[8] Tesfa, B., Mishra, R., Gua, F. and Powles, N. (2010) “Prediction models for density and viscosity of biodiesel and their effects on fuel supply system in CI engines.” Renewable Energy, Vol. 35, pp. 2752-2760.
[9] Shu, Q., Yang, B., Yang, J. and Qing, S. (2007) “Predicting the viscosity of biodiesel fuels based on the mixture topological index method.” Fuel, Vol. 86, pp. 1849–1854.
[10] Barabás, I. (2015). “Liquid densities and excess molar volumes of ethanol+biodiesel binary system between the temperatures 273.15 K and 333.15 K.” Journal of Molecular Liquids, Vol. 204, pp. 95–99.
[11] Freitas, S.V.D., Pratas, M.J., Ceriani, R., Lima, A.S. and Coutinho, J.A.P. (2011). “Evaluation of predictive models for the viscosity of biodiesel.” Energy Fuels, Vol. 25, pp. 352–358.
[12] Ceriani, R., Goncüalves, C.B., Rabelo, J., Caruso, M., Cunha, A.C.C., Cavaleri, F.W. et al. (2007). “Group contribution model for predicting viscosity of fatty compounds.” J. Chem. Eng. Data, Vol. 52, pp. 965-972.
[13] Krisnangkura, K., Yimsuwan, T. and Pairintra, R. (2006). “An empirical approach in predicting biodiesel viscosity at various temperatures.” Fuel, Vol. 85, pp. 107–113.
[14] Pratas, M.J., Freitas, S., Oliveira, M.B., Monteiro, S.C., Lima, A.S. and Coutinho, J.A.P. (2010). “Densities and viscosities of fatty acid methyl and ethyl esters.” J. Chem. Eng. Data, Vol. 55, pp. 3983–3990.
[15] Pratas, M.J., Freitas, S., Oliveira, M.B., Monteiro, S.C., Lima, A.S. and Coutinho, J.A.P. (2011). “Densities and viscosities of minority fatty acid methyl and ethyl esters present in biodiesel.” J. Chem. Eng. Data, Vol. 56, pp. 2175–2180.
[16] Nogueira, C.A., Feitosa, F.X., Fernandes, F.A.N., Santiago, R.S. and de Sant‟Ana, H.B. (2010). “Densities and viscosities of binary mixtures of babassu biodiesel + cotton seed or soybean biodiesel at different temperatures.” J. Chem. Eng. Data, Vol. 55, pp. 5305–5310.
[17] Feitosa, F.X., Rodrigues, M.L., Veloso, C.B., Cavalcante, C.L., Albuquerque, M.C.G. and de Sant‟Ana, H.B. (2010). “Viscosities and densities of binary mixtures of coconut + colza and coconut + soybean biodiesel at various temperatures.” J. Chem. Eng. Data, Vol. 55, pp. 3909–3914.
[18] Tate, R.E., Watts, K.C., Allen, C.A.W. and Wilkie, K.I. (2006). “The densities of three biodiesel fuels at temperatures up to 300° C.” Fuel, Vol. 85, pp. 1004–1009.
[19] Nita, I., Geacai, S. and Iulian, O. (2011). “Measurements and correlations of physico-chemical properties to composition of pseudo-binary mixtures with biodiesel.” Renewable Energy, Vol. 36, pp. 3417-3423.
[20] Ramírez-Verduzco, L.F., García-Flore, B.E., Rodríguez-Rodríguez, J.E. and Jaramillo-Jacob, A.R. (2011). “Prediction of the density and viscosity in biodiesel blends at various temperatures.” Fuel, Vol. 90, pp. 1751–1761.164.
[21] Tate, R.E., Watts, K.C., Allen, C.A.W. and Wilkie, K.I. (2006). “The viscosities of three biodiesel fuels at temperatures up to 300 C.” Fuel, Vol. 85, pp. 1010–1015.
[22] Tat, M.E. and Van Gerpen, J.H. (1999). “The kinematic viscosity of biodiesel and its blends with diesel fuel.” J. Am. Oil Chem. Soc., Vol. 76, pp. 1511-1513.
[23] Yuan, W., Hansena, A.C., Zhang, Q. and Tan, Z. (2005). “Temperature-dependent kinematic viscosity of selected biodiesel fuels and blends with diesel fuel.” J. Am. Oil Chem. Soc., Vol. 82, pp. 195-199.
[24] Krisnangkura, K., Sansa-ard, C., Aryusuk, K., Lilitchan, S. and Kittiratanapiboon, K. (2010). “An empirical approach for predicting kinematic viscosities of biodiesel blends.” Fuel, Vol. 89, pp. 2775–2780.
[25] Grunberg, L. and Nissan, A.H. (1949). “Mixture law for viscosity.” Nature, Vol. 164, pp. 799–800.
[26] Joshi, R.M. and Pegg, M.J. (2007). “Flow properties of biodiesel fuel blends at low temperatures.” Fuel, Vol. 86, pp. 143–151.
[27] Bhat, N. and McAvoy, T.J. (2000). “Use of neural nets for dynamic modeling and control of chemical process systems.” Comput. Chem. Eng., Vol. 14, pp. 573-583.
[28] Moradi, M.R., Nazari, K., Alavi, S. and Mohaddesi, M. (2013). “Prediction of Equilibrium Conditions for Hydrate Formation in Binary Gaseous Systems Using Artificial Neural Networks.” Energy Technol., Vol. 1, pp. 171-176.
[29] Moradi, G., Mohadesi, M. and Moradi, M.R. (2013). “Prediction of wax disappearance temperature using artificial neural networks.” J. Pet. Sci. Eng., Vol. 108, pp. 74-81.
[30] Mohadesi, M., Moradi, G. and Mousavi, H.-S. (2014). “Estimation of Binary Infinite Dilute Diffusion Coefficient Using Artificial Neural Network.” J. Chem. Pet. Eng., Vol. 48, pp. 27-45.
[31] Molga, E. and Cherbanski, R. (1999). “Hybrid first-principle-neural network approach to modeling of the liquid-liquid reacting system.” Chem. Eng. Sci., Vol. 54, pp. 2467-2473.
[32] Fissore, D., Barresi, A.A. and Manca, D. (2004). “Modeling of methanol synthesis in a network of forced unsteady-state ring reactors by artificial neural networks for control purposes.” Chem. Eng. Sci., Vol. 59, pp. 4033-4041.
[33] Kito, S., Satsuma, A., Ishikura, T., Niwa, M., Murakami, Y. and Hattori, T. (2004). “Application of neural network to estimation of catalyst deactivation in methanol conversion.” Catal. Today, Vol. 97, pp. 41-47.
[34] Papadokonstantakis, S., Machefer, S., Schnitzleni, K. and Lygeros, A.I. (2005). “Variable selection and data pre-processing in NN modeling of complex chemical processes.” Comput. Chem. Eng., Vol.29, pp. 1647-1659.
[35] Omata, K., Nukai, N. and Yamada, M. (2005). “Artificial neural network aided design of a stable Co-MgO catalyst of high-pressure dry reforming of methane.” Ind. Eng. Chem. Res., Vol. 44, pp. 296-301.
[36] Himmelblau, D. (2008). “Accounts of experiences in the application of artificial neural networks in chemical engineering.” Ind. Eng. Chem. Res., Vol. 47, pp. 5782-5796.
[37] Hashemipour, H., Baroutian, S., Jamshidi, E. and Abazari, A. (2009). “Experimental study and artificial neural networks simulation of activated carbon synthesis in fluidized bed reactor.” Int. J. Chem. Reactor Eng., Vol. 7, A80.
[38] Nabavi, R., Salari, D., Niaei, A. and Vakil-Baghmisheh, M.-T. (2009). “A neural network approach for prediction of main product yields in methanol to olefins process.” Int. J. Chem. Reactor Eng., Vol. 7, A26.
[39] Khataee, A and Khani, A. (2009). “Modeling of nitrate adsorption on granular activated carbon (GAC) using artificial neural network (ANN).” Int. J. Chem. Reactor Eng., Vol. 7, A5.
[40] Eslamloueyan, R. and Khademi, M.H. (2009). “Estimation of thermal conductivity of pure gases by using artificial neural networks.” Int. J. Thermal. Sci., Vol. 48, pp. 1094–1101.
[41] Eslamloueyan, R. and Khademi, M.H. (2009). “Using artificial neural networks for estimation of thermal conductivity of binary gaseous mixtures.” J. Chem. Eng. Data, Vol. 54, pp. 922–932.
[42] Eslamloueyan, R. and Khademi, M.H. (2010). “A neural network-based method for estimation of binary gas diffusivity.” Chemom. Intell. Lab. Syst., Vol. 104, pp. 195–204.
[43] Encinar, J.M., Sánchez, N., Martínez, G. and García, L. (2011). “Study of biodiesel production from animal fats with high free fatty acid content.” Bioresour. Technol., Vol. 102, pp. 10907–10914.
[44] Haykin, S. (1999). Neural networks: a comprehensive foundation. 2nd Ed. Englewood Cliffs, NJ: Prentice-Hall.
[45] Levenberg, K. (1994). “A method for the solution of certain problems in least squares.” SIAM J. Numer. Anal., Vol. 16, 588–604.
[46] Marquardt, D. (1963). “An algorithm for least-squares estimation of nonlinear parameters.” SIAM J. Appl. Math., Vol. 11, pp. 431–441.
[47] Hagan, M.T. and Menhaj, M. (1994). “Training feedforward networks with the Marquardt algorithm.” IEEE Trans. Neural. Netw., Vol. 5, pp. 989–993.