Measurement of Archie Parameters of Some Carbonate Cores at Full Reservoir Conditions (Short Communication)

Authors

Petroleum Engineering Research Division, Center for Exploration and Production Studies and Research, Research Institute of Petroleum Industry, Tehran, Iran

Abstract

Application of Archie equation in carbonate reservoirs is not easy due to high dependence of its parameters on carbonate characteristics. Carbonates are very heterogeneous in nature and hydrocarbon reserve estimation in these reservoirs of mostly oil-wet and intermediate-wet is highly influenced by the input values of saturation exponent.
To our knowledge, non representative oils have been used in most saturation exponent measurements and not many cases have used live oil for carbonate cores at full reservoir conditions. Performing these experiments at laboratory conditions which differs from reservoir ones would not yield reliable results.
The main effort of this study was to properly measure saturation exponent on some carbonate core plugs of an Iranian reservoir at reservoir conditions using live oil by porous plate technique. Resistivity index and capillary pressure by drainage process on some plugs from pay-zone and resistivity index by imbibition process on some plugs from near and within transition zone of studied reservoir were measured.
Regression fits by using Archie equation were not satisfying. Hence, the regressions were also obtained without taking into account the origin point which insisted the use of a “b” (saturation distribution) factor in the Archie equation.

Keywords


[1] Archie, G.E. (1942). "The Electrical Resistivity Log as an Aid in Determining Some Reservoir Characteristics," Trans. AIME, Vol. 146, PP. 54-67.
[2] Shamsi Ara, T., Talabani, S., Vaziri, H.H. and Islam, M.R. (2001). "In-Depth Investigation of the Validity of the Archie Equation in Carbonate Rocks." SPE 67204.
[3] Longeron, D. G. (1990). "Laboratory Measurements of Capillary and Electrical Properties of Rock Samples at Reservoir Conditions: Effect of Some Parameters." SCA-9023.
[4] Jing, X.D. and Archer, J.S. (1991). "Special Core Analysis Considerations in the Determination of Electrical Properties of Shaly Rocks at Reservoir Conditions." SCA9117.
[5] Anderson, W., Dec. (1986). "Wettability Literature Survey – Part 3: The Effects of Wettability on the Electrical Properties of Porous Media." JPT, PP. 1371-1377.
[6] Potocki, D., Ding, M. and Kantzas, A. (2003). "Carbonate Rock Wettability Interpreted from Capillary Pressure and Imbibition Resistivity Index Analysis." SCA2003-03.
[7] Keller, G.V., (1953). "Effect of Wettability on Electrical Resistivity of Sand." Oil & Gas J., No. 4, PP. 62-5.
[8] Sweeney, S.A. and Jennings, H.Y. Jr, (1960). "Effect of Wettability on Electrical Resistivity of Carbonate Rock from a Petroleum Reservoir." J. Phys. Chem., No. 64, PP. 551-553.
[9] Scendena, E., Bratteli, F., Kooltveit, K. and Normann, H.P., Oct. (1989). "Comparison between Capillary Pressure Data and Saturation Exponent Obtained at Ambient and at Reservoir Conditions." SPE Paper 19592, 64th Annual Tech. Conf. San Antonio, Tx.
[10] Sanyal, S.K., Marsden, S.S. and Ramey, H.J., May 7-10, (1972). "The Effect of Temperature on Electrical Resistivity of Porous Media, Trans. " SPWLA, 13th Ann. Log. Symp., Tulsa.
[11] Jun-Zhi, W. and Lile, O.B. May (1990). "Hysteresis of the Resistivity Index in Berea sandstone, First European Core Analysis Symposium." London-England.
[12] Moss, A. K. and Jing, X. D. (1999). "Resistivity Index and Capillary Pressure Characteristics of Reservoir Sandstones in Different Wettability Conditions." SCA-9945.
[13] Abdassah, D., Permadi, P. and Sumantri, Y. (1998). "Saturation Exponent at Various Wetting Conditions: Fractal Modeling of Thin-sections." J. of Pet. Sci. & Eng. (20), PP. 147-154.
[14] Maute, R.E., May-June (1992). Electrical Logging: State of the Art, The Log Analyst, PP. 206-227.
[15] Mukul, M., Sharma, A. and Garrouch, H. F. Dunlap, Sep. (1991). Effects of wettability, pore geometry, and stress on electrical conduction in fluid-saturated rocks, The Log Analyst, PP. 511-526.
[16] Al-Mahtot, O. B. and Mason, W. E. (1998). "Effect of Fluid Characteristics and Flow Mechanism on Archie Saturation Exponent." SCA-9841.
[17] Adisoemarta, P. S., Anderson, G. A., Frailey, S. M. and Asquith, G. B. (2001). Saturation Exponent “n” in Well Log Interpretation: Another Look at the Permissible Range, SPE 70043, SPE Permian Basin Oil and Gas Recovery Conference.