Simulation of Oil Reservoirs Driving Indices and Recovery Mechanisms

Document Type : Research Paper

Authors

1 Department of Oil and Gas Field Development and Operation, Oil and Gas Faculty, National Mineral Resources University (University of Mines), Saint-Petersburg, Russia

2 Wellsite Supervisor at Iranian Offshore Oil Company, Bahregan, Iran

Abstract

Different recovery mechanisms are activated during the production from reservoirs. Wells sometimes are kept with the injection. Therefore the evaluation of injection indices depended on material injection, seems to be necessary. This study is going to determine the drive indices for a reservoir by making a model using Eclipse. The model consists a gas cap and aquifer, in which there is an injection well used to show water drive index. The summation of reservoir drive indices is equal to one and changing in one drive index can cause changes in the other drive indices. The relation between the all exciting drives and their effects on each other were shown by changing the production conditions in the model. A second model was simulated to know the effects of gas injection process, which is used to keep pressure and production from the reservoir. The role of effective parameters, including gas oil ratio and water cut in 3000 days, were evaluated in the second model. The optimum gas injection rate and influence of drive indices in the simulated field were obtained from the results of this work. 

Keywords


[1] Esor, E., Dresda, S. and Monico, C. (2004). “Use of material balance to enhance 3D reservoir simulation: A case study.” SPE 80907, SPE Ann. Tech. Conf. Exhibition., Houston, Texas.
[2] Ahmed, T.H., Centilmen, A. and Roux, B.P. (2006). “A generalized material balance equation for coalbed methane reservoirs.” SPE 102638, SPE Ann. Tech. Conf. Exhibition., San Antonio, Texas.
[3] Pletcher, J.L. (2000). “Improvements to reservoir material balance methods.” SPE 62882, SPE Ann. Tech. Conf. Exhibition., Dallas, Texas.
[4] Walsh, M.P. (1995). “A generalized approach to reservoir material balance calculations.” J. Can. Pet. Technol., Vol. 34, No. 1, pp. 55-63.
[5] Ahmed, A. and McKinney, P. (2005). Advanced reservoir engineering. Chapter 4, Gulf Prof. Pub. Co., Houston, Texas.
[6] Firoozabadi, A. (2001). “Mechanism of solution gas drive in heavy oil reservoirs.” J. Can. Pet. Technol, Vol. 40, No. 3, pp. 15-20.
[7] Niz-Velasquez, E., Moore, R.G., Mehta, S.A. and Ursenbach, M.G. (2006). “Reservoir simulation assessment of the oil recovery mechanisms in high-pressure air injection (HPAI).” Canadian Int. Petr. Conf., Calgary, Alberta.
[8] Myers, T.J., and Radke, C.J. (2000). “Transient foam displacement in the presence of residual oil: experiment and simulation using a population-balance model. Ind. Eng. Chem. Res., Vol. 39, No. 8, pp. 2725-2741.
[9] Wu, H., Zhou, F. and Wu, Y. (2001). “Intelligent identification system of flow regime of oil–gas–water multiphase flow. Int. J. Multi. Flow., Vol. 27, No. 3, pp. 459-475.
[10] Schilthuis, R. (1936). “Active oil and reservoir energy.” Trans. AIME., Vol. 118, pp. 33-38.
[11] Cole, F.W. (1969). Reservoir Engineering Manual, Gulf Publ. Co., Houston, Texas, pp. 285.
[12] Dake, L.P. (2001). The Practice of Reservoir Engineering. Chapter 3, Elsevier, Amsterdam, Netherlands.
[13] Eclipse 100 Reference Manual, (2009.1). Schlumberger.