Measurement and Modeling of Acridine Solubility in Supercritical Carbon Dioxide

Document Type: paper


1 Department of Chemical Engineering, Tarbiat Modares University, Tehran, Iran

2 Department of Chemical Engineering, Babol Noshirvani University of Technology, Babol, Iran


Supercritical carbon dioxide has gained increasing attention in food and pharmaceutical processing owing to the fact that it is environmentally inexpensive, not flammable, essentially non-toxic, and it has a convenient critical point. Also, it has been attracting much attention in many fields, such as extraction of sensitive materials and pharmaceutical processing and polymerization processes. For designing these processes, solubility data of solute in SCCO2 are needed as the fundamental knowledge. And the correlation and extension of existing equilibrium data is an important step in the application and development of such processes.
 Acridine is a raw material used for the production of dyes and some valuable drugs and its derivatives have antiseptic properties like Proflavine. In this research, the solubility of Acridine in supercritical carbon dioxide was measured at temperatures of 313, 323 and 333 K and in the pressure range of 120 to 350 bar using static method. The crossover pressure of Acridine was observed at about 150 bar. The experimental data were correlated using Peng- Robinson (PR) and Soave- Redlich- Kwong (SRK) equations of state (EOS) and van der Waals mixing rule with one (vdW 1) and two adjustable parameters (vdW 2) and Huron-Vidal mixing rules. For applying the Huron-Vidal mixing rule, NRTL activity coefficient model was used.  The binary interaction parameters of the studied models were reported. The results of average absolute relative deviations (AARD) illustrated good accuracy of the studied models. Furtheremore, the modeling has been done with and without considering the sublimation pressure of the solid (Acridine) as an additional adjustable parameter.  It can be concluded when sublimation pressure is considered as adjustable parameter, the AARD results of the studied models significantly decrease. Also, the estimated values of sublimation pressure of Acridine were reported at different temperatures. The results also showed that, among the studied models, PR- HV model with adjusted Psub has the minimum AARD (2.47 %).


[1] Coimbra, P., Duarte, C.M.M. and de Sousa, H.C. (2006). “Cubic equation-of-state correlation of the solubility of some anti-inflammatory drugs in supercritical carbon dioxide.” Fluid Phase Equilibria, Vol. 239, PP. 188–199.

[2] Garlapati, C. and Madras, G. (2010). “Solubilities of palmitic and stearic fatty acids in supercritical carbon dioxide.” Journal of Chemical Thermodynamics, Vol. 42, PP. 193–197.

[3] Park, C.I., Shin, M.S. and Kim, H. (2009). “Solubility of climbazole and triclocarban in supercritical carbon dioxide: Measurement and correlation.” Journal of Chemical Thermodynamics, Vol. 41, PP. 30–34.

[4] Huang, C. C., Tang, M., Tao, W.H. and Chen, Y.P. (2001). “Calculation of the solid solubilities in supercritical carbon dioxide using a modified mixing model.” Fluid Phase Equilibria, Vol. 179, PP. 67–84.

[5] Banchero, M., Ferri, A., Manna, L. and Sicardi, S. (2006). “Solubility of disperse dyes in supercritical carbon dioxide and ethanol.” Fluid Phase Equilibria, Vol. 243, PP. 107–114.

[6] Bahramifar, N., Yamini, Y. and Shamsipur, M. J. (2005). “Investigation on the supercritical carbon dioxide extraction of some polar drugs from spiked matrices and tablets.” Journal of Supercritical Fluids, Vol. 35, PP. 205–211.

[7] Hojjati, M., Yamini, Y., Khajeh, M. and Vatanara, A. (2007). “Solubility of some statin drugs in supercritical carbon dioxide and representing the solute solubility data with several density-based correlations.” Journal of Supercritical Fluids, Vol. 41, No. 2, PP. 187–194.

[8] Schmitt, W. J. and Reid, R. C., (1986). “Solubility of monofunctional organic solids in chemically diverse supercritical fluids.” Journal of Chemical and Engineering Data, Vol. 31, PP. 204–212.

[9] Dobbs, J. M., Wong, J. M., Lahiere, R. J. and Johnston, K. P. (1987). “Modification of Supercritical Fluid Phase Behavior Using Polar Cosolvents.” Industrial & Engineering Chemistry Research, Vol. 26, PP. 56–65.

[10] Shibata, S. and Sandler, S. (1989). “Critical evaluation of equation of state mixing rules for the prediction of high-pressure phase equilibria.” Industrial & Engineering Chemistry Research, Vol. 28, PP. 1893–1898.

[11] Sheng, Y.J., Chen, P.C., Chen, Y.P. and Wong, D.S.H. (1992). “Calculations of solubilities of aromatic compounds in supercritical carbon dioxide.” Industrial & Engineering Chemistry Research, Vol. 31, PP. 967–973.

[12] Huron, M.J. and Vidal, J. (1979). “New Mixing Rules in Simple Equation of State for Representing Vapor-Liquid Equilibria of Strongly Non-ideal Mixtures.” Fluid Phase Equilibria, Vol. 3, PP. 255–271.

[13] Peng, D.Y. and Robinson, D.B. (1976). “A new two constant equation of state.” Industrial & Engineering Chemistry Fundamentals, Vol. 15, PP. 59–64.

[14] Soave, G. (1993). “Equilibrium constants from a modified Redlich–Kwong equation of state.” Chemical Engineering Science, Vol. 27, PP. 1197–1203.

[15] Yamini, Y., Fathi, M. R., Alizadeh, N. and Shamsipur, M. (1998). “Solubility of Dihydroxybenzene Isomers in Supercritical Carbon Dioxide.” Fluid Phase Equilibria, Vol. 152, PP. 299–305.

[16] Renon, H. and Prausnitz, J.M. (1965). “Local compositions in thermodynamic excess functions for liquid mixtures.” AIChE Journal, Vol. 14, PP. 135–144.

[17] Bartle, K.D., Clifford, A.A. and Shilstone, G.F. (1992). “A model for dynamic extraction using a supercritical fluid.” Journal of Supercritical Fluids, Vol. 5, PP. 220–225.

[18] Skerger, M., Novk-Pintaric, Z., Kenz, Z. and Kravanja, Z. (2002). “Estimation of solid solubilities in supercritical carbon dioxide: Peng–Robinson adjustable binary parameters in the near critical region.” Fluid Phase Equilibria, Vol. 203, PP. 111–132.

[19] Gordillo, M.D., Blanco, M.A., Pereyra, C. and Mart´? nez de la Ossa, E.J. (2005). “Thermodynamic modeling of supercritical fluid-solid phase equilibrium data.” Computers & Chemical Engineering, Vol. 29, PP. 1885–1890.

[20] Reverchon, E., Della Porta, G., Taddeo, R., Pallado, P. and Stassi, A. (1995). “Solubility and micronization of Griseofulvin in supercritical CHF3.” Industrial & Engineering Chemistry Research, Vol. 34, PP. 4087–4091.

[21] Prausnitz, J.M., Rüdiger, N.L. and Gomes de Azevedo, E. (1999). Molecular Thermodynamics of Fluid-Phase Equilibria. 3th. Ed., Prentice-Hall Pub. Co. New Jersey.

[22] Reid, R.C. Prausnitz, J.M. and Poling, B.E. (1987). The Properties of Gases and Liquids. 4th. Ed., McGraw-Hill Book Co. New York.