Application of Decline Analysis in Fractured Reservoirs, Field Case Studies

Document Type: paper

Authors

1 Department of Petroleum Engineering, Marvdasht Branch, Islamic Azad University, Marvdasht, Iran

2 Australian School of Petroleum, The University of Adelaide, Adelaide, Australia

3 Iranian Central Oil Field Co., ICOFC, National Iranian Oil Co., NIOC, Shiraz, Iran

Abstract

Decline curve analysis has some advantages over transient well test analysis in which it is not required to shut-in the well and also wellbore storage effects do not exist. Few studies have been done on decline curve analysis of naturally fractured reservoirs but there are even some limitations with available models. On the other hand well test could be expensive and in some operational conditions shutting the well to obtain reservoir parameters is almost impossible. Therefore, investigating the applicability of homogenous reservoir decline models for production data analysis of naturally fractured reservoirs is necessary. In this paper the most important decline models have been used to evaluate reservoir parameters in three Iranian naturally fractured reservoirs and the results have been compared to transient well test analysis. A useful and applicable procedure is also introduced to correct the initial production data when they do not have necessary conditions. The results show that Agarwal-Gardner and Blasingame type curves predict acceptable values for permeability compared to transient well test analysis while Fetkovich type curve cannot predict accurate values. Determined skin values in all wells of the three studied reservoirs are negative. Negative values can be considered to be affected by existing fracture networks in the vicinity of producing wells and also periodic well stimulations. The results also show that Neglecting produced condensates of gas condensate reservoirs with Liquid-Gas Ratio (LGR) less than 100 bbl/MMscf cannot significantly affect decline curve analysis results.

Keywords


[1] Arps, J. (1944). “Analysis of Decline Curves.”Proc., Int. A.I.M.E Houston meeting, Houston, USA, PP. 228-247.

[2] Fetkovich, M. J. (1973). “Decline Curve Analysis Using Type Curves.”Proc., 48th Int. SPE Conf., Las Vegas, USA, PP. 1067-1077.

[3] Fetkovich, M. J. and et al. (1987). “Decline Curve Analysis Using Type Curves-Case Histories.”Proc., Int. SPE Annual Technical Conference and Exhibition,Houston, USA, PP. 637-656.

[4] Chaudhry, A. (2003). Gas Well Testing Handbook.1st. Ed. Chapter 16, Gulf Professional Pub. Co., Burlington.

[5] Chen, H. and Teufel, L. (2000). “A New Rate Time Type Curve for Analysis of Tight Gas Linear and Radial Flows.”Proc., Int. SPE Annual Technical conf., Texas, USA, SPE 63094.

[6] Carter, R. (1985). “Type Curves for Finite Radial and Linear Gas Flow Systems: Constant Terminal Pressure Case.”Proc., Int. SPE Rocky Mountain Regional Meeting, Denver, USA, PP. 142-151.

[7] Ahmed, T. (2006). Reservoir Engineering Handbook.3rd. Ed. Chapter 16, Gulf Professional Pub. Co., Burlington.

[8] Blasingame, T. and Mc Cray, T. (1993). “Decline Curve Analysis for Variable Pressure Drop/Variable Flow Rate Systems.”Proc., Int. SPE Gas Symposium, Houston, USA, SPE 21513.

[9] Blasingame, T. and Palacio, J. (1993). “Decline Curve Analysis Using Type Curves-Analysis of Gas Well Production Data.”Proc., Int. SPE Joint Rocky Mountain Regional and Low Permeability Reservoirs Symposium, Denver, USA, SPE 25909.

[10] Doublet, L. E., McCollum, T. J. and Blasingame, T. (1994). “Decline Curve Analysis Using Type Curves-Analysis of Oil Well Production Data Using Material Balance Time: Application to Field Cases.” Proc., Int. Petroleum Conference and Exhibition of Mexico, Veracruz, Mexico, SPE 28688.

[11] Anash, J., Blasingame, T. and Knowles R. S., (1996). “A Semi-Analytic (p/z) Rate-Time Relation for the Analysis and Prediction of Gas Well Performance.” Proc., Int. Mid-Continent Gas Symposium, Amarillo, USA, SPE 35268.

[12] Agarwal, R., Gardner, D., Kleinsteiber, S. and Fussell, D. (1998). “Analyzing Well Production Data Using Combined Type Curve and Decline Curve Analysis Concepts.” Proc., Int. SPE Annual Technical Conference and Exhibition, Louisiana, USA, SPE 49222.

[13] Ilk, D., Rushing, J. A., Blasingame, T. A. (2009). “Decline Curve Analysis for HP/HT Gas Wells: Theory and Applications.” Proc., Int. SPE Annual Technical Conference and Exhibition, Louisiana, USA, SPE 125031.

[14] Van Golf Racht, T. (1982).Fundamentals of Fractured Reservoir Engineering. 1st. Ed. Chapter 9, Elsevier Scientific Publ. Co., Amsterdam.

[15] Shahverdi, H. R. (2005). Determining of Fractured Reservoir Properties by Decline Rate.M.Sc. Thesis, Tehran University, Tehran, Iran.

[16] Gerami, Sh. and PooladiDarvish, M. (2007). “Decline Curve Analysis for Naturally Fractured Gas Reservoirs: A Study on the Applicability of Pseudo Time and Material Balance Pseudo Time.”Proc., Int. Petroleum Technology Conference, Dubai, UAE, IPTC 11278.

[17] Zareenejad, M. H., KalantariAsl, A., Nasriani, H. R.and Zargar, Gh. (accepted to publish 2011). “Analysis and Comparison of Decline Models, A Field Case Study of a Naturally Fractured Gas Condensate Reservoir.” Energy Sources, Part A: Recovery, Utilization, and Environmental Effects.

[18] F.A.S.T. RTA User Manual. Version 4.5.Fekete Co., Canada.